What Roof Replacement Includes
A roof estimate follows a full roof inspection: decking condition, flashing, ventilation, and previous repairs. The scope of work is written before anything is torn off.
- Tear-off of existing shingle, underlayment, and roofing felt down to the decking
- Deck inspection and replacement of rotted plywood or OSB sheathing
- Installation of ice-and-water shield at eaves and valleys, then synthetic underlayment
- New drip edge, pipe flashing, chimney flashing, and step flashing
- Ridge cap, ridge vent, and soffit vent ventilation
A dumpster sits on site. Crews use scaffold, ladder, and safety harness, plus roofing square layout, nail gun, air compressor, pry bar, and roofing shovel.
Final cleanup includes magnetic sweep for nails and debris.
Quality & Materials Standards
Material choice should match the home. Architectural shingle and dimensional laminated products are the common upgrade over three-tab shingle.
Metal panel and standing-seam panel suit coastal exposure.
Some homes carry tile, clay tile, or concrete tile, which demand a reinforced substrate and careful fastening; slate and cedar shake appear on older or custom homes.
Florida building code governs attachment, uplift resistance, and ventilation.
A roofing contractor must secure sheathing with the correct nail, screw, or fastener pattern, then seal penetrations with sealant, caulk, or mastic.
Roof cement and primer are used where required.
Flat or low-slope sections take membrane systems: tpo, epdm, pvc membrane, modified bitumen, or built-up roof. Coatings matter too.
Elastomeric coating, acrylic coating, silicone coating, and polyurethane coating extend service life and improve reflective performance.
Cure time, coverage rate, and tensile strength vary by product, so read the spec sheet.
Local Service Areas
Downtown Titusville
Historic core with the oldest housing stock in the city, close to Sand Point Park and the Indian River.
- 1940s–1950s wood-frame homes with original plank decking
- Wood shake and three-tab shingle that crack and curl from uv degradation
- Corroded pipe boot and pipe flashing at plumbing vents
- Rotted fascia, soffit, and rake boards from years of salt air
- Tar and bitumen patches layered over old roofing felt
South Titusville
Mid-century block homes on tight lots, many with low-slope additions and carports.
- 1950s–1970s single-story concrete block with plywood decking
- Built-up roof and tar sections that pond water and blister
- Failed apron flashing where additions meet the main roofline
- Clogged gutter and downspout causing eave rot
- Loose ridge cap after wind damage from summer storms
Riverside
Waterfront-adjacent blocks where salt spray and wind load hit hardest.
- Metal panel and corrugated panel with rusted fastener heads
- Standing-seam panel seams lifting under thermal movement
- Wind damage tearing shingle tabs at the verge and hip
- Counter-flashing and counterflashing rust at chimney and parapet
- Salt-driven corrosion on anchors and drip edge
Titusville North
Newer ranch subdivisions from the 2000s, mostly stucco and vinyl siding.
- 2000s-era stucco and vinyl siding ranch homes
- Architectural shingle reaching end of life ahead of schedule
- Inadequate soffit vent and ridge vent causing attic heat and moisture
- Cracked boot flashing and vent boot at plumbing stacks
- Missing ice-and-water shield at valleys on steep gable roofs
West Titusville
Inland, wooded lots where tree cover and shade change how a roof ages.
- Shade and debris holding moisture on the roof deck and sheathing
- Moss and organic growth lifting shingle edges
- Damaged step flashing and chimney flashing at masonry chimneys
- Clogged valleys trapping debris and backing up water
- Undersized ventilation with no attic fan, trapping heat
